GFSK transceiver multi carrier frequence & multi baud rate
Hello, I am looking for a tranceiver multi carrier frequence & multi baud rate for the ISM band 868 MHz, I have seen the component...
View ArticleADATE318 IBIS model
Hi ADIer, Where can I find the IBIS model of ADATE318? I can not do simulation without it. I can't find a suitable place to put this request, ADATE318 integrated DACs, maybe I can put it here. Thanks...
View ArticleWhat is TECGAIN of ADN8834 DS?
Hi, I have a question about TEC controller ADN8834. I can see an equation of f_0dB in DS at p18.Can you explain what TECGAIN in it? from Fig 35, 0dB should be at 1/(2*pi*R_1*C_1). But f_0dB of...
View ArticleHaving noise problems w/ AD1988A / ASUS/ M2N-SLI Deluxe
I have the latest drivers and a creative 7.1 speaker setup. My monitor is a Olevia 42 inch LCD TV. I have this background hum. Just like when a guitar is plugged into an amp. There are times when it...
View ArticleSuggessions required to improve perfomance of ADF7021-V
Hi all, I have interface ADF7021-V daughterboard with an 8 bit microcontroller to transmit a realtime ECG signal. I found the system is working perfectly without any error in case of Line Of Sight...
View ArticleADF7012 capable of Biphase L Modulation
Hello:Is the ADF7012 capable of biphase L modulation scheme? The application would be for search and rescue beacon transmitter.Thank you,Frank
View ArticleADN2841 input to output propagation delay
Hello, Do you have any data for ADN2841 input to output(IMODP) propagation delay at 25C degree and Vcc=5V? Best regards and Thanks,Ian
View ArticleQuestions on pins MIX_I, MIX_Q, FILT_I and FILT_Q for ADF 7020
Dear Sir/Madam, My primary goal is to find the phase information of the received signal using a quadrature demodulation architecture receiver/transceiver. Therefore the signals I am most interested in...
View ArticleADIS16209CCCZ - INCLINOMETER
We have on regular basis the same complains for ADIS16209CCCZ. The customers report as follows: ... these IC are shorted to GND as soon as they were soldered in place while using small programmable...
View ArticleControlling digital potentiometer (AD5142) by Arduino UNO
Hi, I am trying to control digital potentiometer (AD5142) by Arduino UNO.Here is the pin configuration of AD5142.I connect SCLK pin to 13 pin of Arduino (serial clock pin), SDI pin to 11 pin of Arduino...
View ArticleADA4571, min and max pitch between two poles when linear config.
Hi, Regarding to AMR angle sensor ADA4571 when used in linear configuration, I would like to know,a) Minimum and Maximum pitch between a north and south pole which available to be used.b) Accuracy data...
View ArticleCan EVAL-ADF70xxMBZ2 detect sticky tag
Hello, I am using a sticky tag from Alien Technologies (ALN-9640 Squiggle® Inlay). Can the EVAL-ADF70xxMBZ2 (with ADF7020 DB) read the data from this tag. I am using 'ADIismLINK config SW' to display...
View ArticleDifference between ADN8834CB-EVALZ and ADN8834MB-EVALZ
What is the difference between ADN8834CB-EVALZ and ADN8834MB-EVALZ? Do you have any additional information or datasheet for the eval kits?
View ArticleQuestion Regarding AD8339
Hello to everyone in Engineer Zone, I wish to post a technical inquiry about the AD8339. According to the datasheet for product AD8339 Revision B on page 29, and with reference to the section "using...
View Articletime-to-digtial or time-to-analog converter
We need to measure the time duration between two pulses (separation range 5ns to 40ns, resolution <200ps, >50k measurements/s). I searched analog.com but did not find any chip dedicated for such...
View ArticlePhysical measurement principle ADIS Analog Devices
hello,I'm interested inthemeasurement principleof the ADIS16006. Does thisworksoncapacitive,orpiezoelectricalprinciple? If piezoelectrical principle, electrical or resistive?Thanks for the comment.
View ArticleAD8672 Open-Loop Gain and Phase Shift vs. Frequency & Output Impedance vs....
Hi there, We are using the SPICE model of AD8672 to simulate the open-loop gain & phase shift vs. frequency & output impedance vs. frequency. It turns out to be quite different from the...
View Articlead5522-output voltage is a Sine wave when Fin is a constant
Dear Sir/Madam. I am using a extent range. A external amplier is connected to Exfoh.output voltage is a Sine wave when Fin is a constant. The frequence is 10K Hz.VREF is confirm as 5VThe supplies is...
View ArticleAbout how to use ADN2818
So I'm outsider of SONET, I query you about foundamental usage of ADN2818. Q1.I want to use it as clock and data separater from "enbedded clock signal" like a 8B10B. If it possible,Q2.Dose it can...
View Article320*240 resistive touch screen calibration problem
Hi every one.I have 320*240 LCD with resistive touch screen and touch screen controller of AD7843 ( All is together in one LCD from topway: KM2088S). I want to know what is the best way to calibrate...
View Article