ADF7021, 3FSK modulation and supported data rate?
Hi everyone, I am wondering if ADF7021 supports baud rate 19.2 Kbps with 3FSK modulation? Thanks
View ArticleADXL001 Output filtering
Data sheet recommends a 1nF capacitor on the output.Table says a minimum of 1000pF (1nF).Other devices publish the output resistance to make understanding the device behavior easier.Data sheet of the...
View ArticleHow to connect a laser with common PD-anode and LD-cathode to ADN2847?
Hi All, I'd like to know a following point about ADN2847 application circuit.According to Figure 15 in the datasheet of ADN2847(RevB), a laser with common PD-cathode and LD-anode is used for this...
View ArticleADA4571 companion device for absolute angle
Hi All, The ADA4571 output sine and cosine voltage.My customer needs absolute angle data without need for calculation in MCU, because his MCU is busy.Do you have any recommendation for converting sine...
View ArticleEMG Isolation in the case of a processor with an in-built ADC.
Hello Bill,I went through a discussion initiated by Yee http://ez.analog.com/thread/6389?tstart=0 in which you have discussed choosing an appropriate isolation scheme for an ECG system. I too have...
View ArticleQuestion for digital interface of AD9866 at half-duplex and master mode?
I am using AD9866. I have question about its digital interface when AD9866 is at half-duplex and master mode.the pin s of RXEN and TXEN are connected together with Bus_Ctr of ASIC. How can I identify...
View ArticleHelp whit ADIS 16405
Hi my name is Jorge Piatti from Argentina!! i buy a sensor ADIS 16405 IMU, and need some help understanding how to interpret the data sent by the gyroscope. If anyone can help me understand that no...
View ArticleADF7021 vs ADF7021-N register differences
Hello, Beyond the Register 1 changes required based on the output frequency, are there any other register differences between the ADF7021 and ADF7021-N? I am trying to use the same register settings...
View ArticleProblem with AGC on ADF7021-N
Hello, I am facing a strange issue with AGC on the ADF7021-N chip. I am using an external oscillator at 14,7456 MHz, listening to a transmitter sending analog audio at 324,0875 MHz and my register...
View Articleadf7021-N
which is the best protocol to interface adf7021-N with a microcontroller and why
View ArticleHow can I get the ADRadioNet for ADF7023?
Is the protocol developed by ADI available for ADF7023?How can I download it?
View ArticleADCMP573 Eval Board Questions
I have a couple of questions about the ADCMP573 and its Eval board. Does the HYS Pin also affect the hysteresis of the Latch enable pins? If I leave the HYS Pin disconnected, how much less hysteresis...
View ArticleAD630 Lock-in Amp
Hello everyone, I am looking to implement a lock-in amplifier in the range of 100kHz to 1MHz to obtain amplitude and phase information. Any thoughts on whether the AD630 will be ok for this frequency...
View ArticleEMG Isolation in the case of a processor with an in-built ADC.
Hello Bill,I went through a discussion initiated by Yee http://ez.analog.com/thread/6389?tstart=0 in which you have discussed choosing an appropriate isolation scheme for an ECG system. I too have...
View ArticleAD7843
Hello, I'm developing a solution that contains a TS module and uses an AD7843 to interface to a Microchip PIC18F4550, but I am not able to read the values X andY. I followed the instructions in the...
View ArticleADF7012 RF output impedance
Dear, Can anyone kindly provide us RF output impedance of ADF7012 around 145MHz?We'd really appreciate if anyone has data on this as we're not equipped with load-pull measurements. Thank you in...
View Article320*240 resistive touch screen calibration problem
Hi every one.I have 320*240 LCD with resistive touch screen and touch screen controller of AD7843 ( All is together in one LCD from topway: KM2088S). I want to know what is the best way to calibrate...
View ArticleHaving noise problems w/ AD1988A / ASUS/ M2N-SLI Deluxe
I have the latest drivers and a creative 7.1 speaker setup. My monitor is a Olevia 42 inch LCD TV. I have this background hum. Just like when a guitar is plugged into an amp. There are times when it...
View ArticleHow to configure the AD9866 registers?
I am using the AD9866 bidirectional DAC and ADC chip. And now I am encountering an issue that don't know how to configure the registers in the AD9866.Is there somebody can guide me the correct...
View ArticleAD8186 Video distortion
Hi All, W are seeing distortion in the video seen in TV when AD8186 is connected. Attached is the same (only Y was connected to AD8186, so only black and white picture is seen). The test set up is as...
View Article