Having noise problems w/ AD1988A / ASUS/ M2N-SLI Deluxe
I have the latest drivers and a creative 7.1 speaker setup. My monitor is a Olevia 42 inch LCD TV. I have this background hum. Just like when a guitar is plugged into an amp. There are times when it...
View ArticleAD8186 Video distortion
Hi All, W are seeing distortion in the video seen in TV when AD8186 is connected. Attached is the same (only Y was connected to AD8186, so only black and white picture is seen). The test set up is as...
View ArticleAD22151 Eval Board
Hello, I am looking for an eval board for the AD22151. Is there one that is available? Thanks!
View ArticlePSpice models
Hi Engineers, I am trying to simulate a circuit on my PC using one of Analog Devices models, "ADA4817 SPICE Macro Model" I am having trouble using this circuit model file and finding information on how...
View ArticleADC's with function amplitude detector
HI ROB! I DESIGNED ADC's with function amplitude detector.THESE ADC's may be apply for direct conversion receivers,power meters,,chips with adaptive signal processing.THESE...
View ArticleHow to configure the AD9866 registers?
I am using the AD9866 bidirectional DAC and ADC chip. And now I am encountering an issue that don't know how to configure the registers in the AD9866.Is there somebody can guide me the correct...
View ArticleADF7021, 3FSK modulation and supported data rate?
Hi everyone, I am wondering if ADF7021 supports baud rate 19.2 Kbps with 3FSK modulation? Thanks
View ArticleMesh network with ADF7021
Hi all, I have interfaced an ADF7021V for transferring a realtime biomedical signal. Now I would like to create a mesh network for data transfer with this device. Is the higher layer protocols...
View ArticleADF7021 with external Rx/Tx switch (ADG919)
Hi, we have made and are using RF modules based on the ADF7021 transceiver with it's internal Rx/Tx switch. So far we are very satisfied with its performance. But we would like to go one step further...
View ArticleOptical Module Development Platform 2.5 Gbps Transmitter with Digital...
Hello, I am a graduate student from Rochester Institute of Technology, Rochester, NY. I am currently looking for a SFP development board for our fiber optics lab. I happened to come across your...
View ArticleProblem starting EVAL-AD9837SDZ software
Analog Engineers, I have two EVAL-AD9837SDZ boards that I would like to program on my computer, but I am having an issue getting the software to open. The program can't locate the LabVIEW Run-Time...
View ArticleADF7021 Daughter board ADF7021DBZ5
Hi, I have this daughter board (ADF7021DBZ5) which i will stream to 144 MHz, then my question is, which components I need on this board to transmit at the desired frequency?, Since this board does not...
View ArticleHow to connect a laser with common PD-anode and LD-cathode to ADN2847?
Hi All, I'd like to know a following point about ADN2847 application circuit.According to Figure 15 in the datasheet of ADN2847(RevB), a laser with common PD-cathode and LD-anode is used for this...
View ArticleSingle supply ECG front end without RLD
How can we realize a single supply ECG front end without using Right Leg Drive? Thanks.
View ArticleProblem with AGC on ADF7021-N
Hello, I am facing a strange issue with AGC on the ADF7021-N chip. I am using an external oscillator at 14,7456 MHz, listening to a transmitter sending analog audio at 324,0875 MHz and my register...
View ArticleHaving noise problems w/ AD1988A / ASUS/ M2N-SLI Deluxe
I have the latest drivers and a creative 7.1 speaker setup. My monitor is a Olevia 42 inch LCD TV. I have this background hum. Just like when a guitar is plugged into an amp. There are times when it...
View ArticleADF7242 RC_Ready after Power On?
The ADF7242 data sheet suggests that, before issuing a radio controller command a SPI_NOP should be sent to check the status of the RC_READY bit of the status word ("it is, therefore, necessary to read...
View ArticleADF7020 communication distance issue
chip is ADF7020, operation frequency is 470MHz, transmit power is 1W, receive sensitivity is -108dBm, but communication distance is only 300-400m, selected Antenna is 470MHz., pls help analyze, in...
View ArticlePSpice models
Hi Engineers, I am trying to simulate a circuit on my PC using one of Analog Devices models, "ADA4817 SPICE Macro Model" I am having trouble using this circuit model file and finding information on how...
View ArticleAD22151 Eval Board
Hello, I am looking for an eval board for the AD22151. Is there one that is available? Thanks!
View Article