How to connect a laser with common PD-anode and LD-cathode to ADN2847?
Hi All, I'd like to know a following point about ADN2847 application circuit.According to Figure 15 in the datasheet of ADN2847(RevB), a laser with common PD-cathode and LD-anode is used for this...
View ArticleADF7021-N CLKOUT frequency
Hi!I am working with the ISM transceiver ADF7021-N and I´d need to know the value of the frequency , by default, of the CLKOUT signal from the SPI interface.I can not find it on the datasheet, Thank...
View ArticleSuggessions required to improve perfomance of ADF7021-V
Hi all, I have interface ADF7021-V daughterboard with an 8 bit microcontroller to transmit a realtime ECG signal. I found the system is working perfectly without any error in case of Line Of Sight...
View ArticleSupply voltage for temp sensor ADATE318
What is supply voltage (VDD_TERM) for temp sensor ADATE318. I did not find this information in the datasheet.
View ArticleADATE318 IBIS model
Hi ADIer, Where can I find the IBIS model of ADATE318? I can not do simulation without it. I can't find a suitable place to put this request, ADATE318 integrated DACs, maybe I can put it here. Thanks...
View Articledemodulation sin o square wave?
Hi,i'd like to use AD8333 to demodulate a pass-band signal with 200kHz local oscillator.The datasheet says that i can use both sin wave and square wave. My question is:The use of a square wave produces...
View ArticleADA4571 sensing tooth of gear wheel
Hello, Below is a figure copied from CN0332.AMR sensor senses magnetic field. Gear wheel or rack is not a magnet. I wonder how magetic field is created from a metal as shown the figure? Is a specific...
View ArticleAD8672 Open-Loop Gain and Phase Shift vs. Frequency & Output Impedance vs....
Hi there, We are using the SPICE model of AD8672 to simulate the open-loop gain & phase shift vs. frequency & output impedance vs. frequency. It turns out to be quite different from the...
View ArticleADG3245 package question - [LFCSP] (CP-20) package
The ADG3245 level shifter shows an exposed thermal pad for the20-Lead Lead Frame Chip Scale Package [LFCSP] (CP-20) package. Can I tie the thermal pad to ground? I apologize if this is the wrong...
View ArticleADA4571 Evaluation Software doesn't be opened
Hi All, I am now trying to install the ADA4571 Evaluation Software into my PC, it doesn't work so far.I am trying to install it along with the installation procedure written in theUG-739.The software...
View ArticleA series of questions about ADATE318
1. How to get the ibis model of the ADATE318?2. What the difference between the pin PPMU_Sx and PMU_Sx? How to use these pins in application?3. How to connect the kinds of GND in the application, such...
View ArticleADF7242 Payload
We are looking for an RF transceiver to be used for data streaming. The ADF7242 seems to have a 128 byte limitation to the packet size.Anybody knows how much data can we send on the same channel during...
View ArticleAbout ADF7023's Daugher board
Hi, I bought ADF7023 daughterboard, and I found the antena in the box.But I can find any information on this antena.Could you tell me How I can get the datasheet of it? Best,Tarzan
View ArticleESD Ratings for ADR5040/ADR5041
Hello, I need the ESD rating test date for the following two devices: ADR5040BKSZ-REEL7ADR5041BKSZ-REEL7 I also would like to know what test standard(s) is used for ESD qualification? Is there a link...
View ArticleADF7020-1 question
I want to be able to offer two frequency ranges, one being ~600MHz and the other being ~900 MHz. I'm wondering if I can expand the range of the 7020-1 to get up to the 900MHz. It looks like the -1...
View ArticleADF7021-N CLKOUT frequency
Hi!I am working with the ISM transceiver ADF7021-N and I´d need to know the value of the frequency , by default, of the CLKOUT signal from the SPI interface.I can not find it on the datasheet, Thank...
View Articleadf7021-N
which is the best protocol to interface adf7021-N with a microcontroller and why
View ArticleQuestion Regarding AD8339
Hello to everyone in Engineer Zone, I wish to post a technical inquiry about the AD8339. According to the datasheet for product AD8339 Revision B on page 29, and with reference to the section "using...
View ArticleADF7242 GFSK sport mode
I purchased two dev kits for the ADF7242 and am trying to configure them to have one be in the tx GFSK Sport mode (2Mbps, sample on falling edge) and one in rx so that I can feed a bitstream through...
View ArticleADN2841 input to output propagation delay
Hello, Do you have any data for ADN2841 input to output(IMODP) propagation delay at 25C degree and Vcc=5V? Best regards and Thanks,Ian
View Article