ADA4571 Evaluation Software doesn't be opened
Hi All, I am now trying to install the ADA4571 Evaluation Software into my PC, it doesn't work so far.I am trying to install it along with the installation procedure written in theUG-739.The software...
View ArticleClik here to view.
ADA4571 sensing tooth of gear wheel
Hello, Below is a figure copied from CN0332.AMR sensor senses magnetic field. Gear wheel or rack is not a magnet. I wonder how magetic field is created from a metal as shown the figure? Is a specific...
View ArticlePhysical measurement principle ADIS Analog Devices
hello,I'm interested inthemeasurement principleof the ADIS16006. Does thisworksoncapacitive,orpiezoelectricalprinciple? If piezoelectrical principle, electrical or resistive?Thanks for the comment.
View ArticleHow to connect a laser with common PD-anode and LD-cathode to ADN2847?
Hi All, I'd like to know a following point about ADN2847 application circuit.According to Figure 15 in the datasheet of ADN2847(RevB), a laser with common PD-cathode and LD-anode is used for this...
View ArticleAD8672 Open-Loop Gain and Phase Shift vs. Frequency & Output Impedance vs....
Hi there, We are using the SPICE model of AD8672 to simulate the open-loop gain & phase shift vs. frequency & output impedance vs. frequency. It turns out to be quite different from the...
View ArticleADF7021 series transceivers
Having to design a new family of narrow-band, VHF and UHF transceivers based on the ADF7021 series of chips, I would be very grateful if i could get some info about: a) The fundamental differences...
View ArticleSoftware drivers for ADF7023-J
I have a design using the ADF7023-J xceiver and was trying to pull in software to initialize & configure it with my Atmel micro. I downloaded the adf7023.c and adf7023.h files which appear to have...
View ArticleESD Ratings for ADR5040/ADR5041
Hello, I need the ESD rating test date for the following two devices: ADR5040BKSZ-REEL7ADR5041BKSZ-REEL7 I also would like to know what test standard(s) is used for ESD qualification? Is there a link...
View Articleapplication ADN2841
Hello!I am going to use ADN2841 in my design, but I have got some questions.1. The ADN2841 is very good for our conditions, but it has a small current of modulation. I have got a laser diode module...
View ArticleSimulation software and a library for ADN3000-06 ic
I am a university student doing my final year university project.Part of My project is to design a fiber optic receiver.I am employing Analog devices ADN3000-06-50A-PT7 ic for this purpose.I am...
View ArticleADF7025 for Wireless audio with ADAU144x DSP
Hi Guys Is there any information on using this as a wireless audio TX/RX im looking at adding wireless transmission to my DSP. I have looked at the data sheets but they all reference the BlackFin DSP...
View ArticlePSpice models
Hi Engineers, I am trying to simulate a circuit on my PC using one of Analog Devices models, "ADA4817 SPICE Macro Model" I am having trouble using this circuit model file and finding information on how...
View ArticleHaving noise problems w/ AD1988A / ASUS/ M2N-SLI Deluxe
I have the latest drivers and a creative 7.1 speaker setup. My monitor is a Olevia 42 inch LCD TV. I have this background hum. Just like when a guitar is plugged into an amp. There are times when it...
View ArticleDivision with AD538
I am trying to do on-board division with the AD538 chip. I have to voltage inputs which can have either negative or positive polarity. The discussed cases in the data sheet are clear for when the...
View ArticleADCMP573 Eval Board Questions
I have a couple of questions about the ADCMP573 and its Eval board. Does the HYS Pin also affect the hysteresis of the Latch enable pins? If I leave the HYS Pin disconnected, how much less hysteresis...
View ArticleClik here to view.
ADCMP572 VTT pin confusion
We've received 2 ADCMP572 eval boards, but unfortunately the documentation for the part and the eval board seems to be inconsistent.As a result, I have a question: should VTT (pin 8) be tied to GND or...
View ArticleProblem with AGC on ADF7021-N
Hello, I am facing a strange issue with AGC on the ADF7021-N chip. I am using an external oscillator at 14,7456 MHz, listening to a transmitter sending analog audio at 324,0875 MHz and my register...
View Articledemodulation sin o square wave?
Hi,i'd like to use AD8333 to demodulate a pass-band signal with 200kHz local oscillator.The datasheet says that i can use both sin wave and square wave. My question is:The use of a square wave produces...
View ArticlePhysical measurement principle ADIS Analog Devices
hello,I'm interested inthemeasurement principleof the ADIS16006. Does thisworksoncapacitive,orpiezoelectricalprinciple? If piezoelectrical principle, electrical or resistive?Thanks for the comment.
View Articleapplication ADN2841
Hello!I am going to use ADN2841 in my design, but I have got some questions.1. The ADN2841 is very good for our conditions, but it has a small current of modulation. I have got a laser diode module...
View Article